Superplastic forming method of titanium alloy sheet

The superplastic forming methods of titanium alloy sheets can be roughly divided into the following three types: (1) vacuum forming; (2) air pressure forming (blow molding); (3) compression molding (coupled mold forming). The first two are common methods of forming plastic (or glass) products. The superplastic forming of titanium plate belongs to viscous or semi-viscous flow deformation, so low pressure forming can be used. Air pressure forming can also be combined with vacuum forming.
1. Vacuum forming method
The vacuum forming method can be divided into punch method and die method.
The punch method is a forming method in which heated wool is adsorbed on the punch and has the internal shape of the part. It is used to form parts that require high internal dimensional accuracy. The die method is a forming method in which heated wool is adsorbed on a die having the shape of a part. It is used to form parts that require high dimensional accuracy. Generally speaking, the former is used to form deep containers, and the latter is used to form shallow containers.
Vacuum forming is also a kind of air pressure forming, but the forming pressure can only be one atmospheric pressure. Therefore, for titanium plates, only parts with thin thickness, simple shape, and gentle curvature can be formed. It is not suitable for forming parts with thick thickness, complex shape, and severe deformation.

info-399-400

2. Air pressure molding method (blow molding method) This is a special bulging process.
Traditional bulging processes are achieved by mechanical, hydraulic or explosive bulging. The pressure and energy used are relatively high, and due to the limitation of material plasticity, the amount of deformation is generally not too large. Blow molding is a molding method that can obtain large deformation with low energy and low pressure. It is a sheet forming technology that is different from traditional technical concepts. Since the metal is free during the deformation process, almost all the power is consumed in the deformation work, and the friction loss is very small (for free blow molding, there is no friction loss), which is fundamentally different from other stamping forming.
Blow molding can be divided into free blow molding and in-mold blow molding. In-mold blow molding is characterized by half-mold molding, which is similar to vacuum molding and is also divided into punch molding and compression molding; the difference is that the molding pressure can be greater than one atmosphere, and the air source system can adjust the pressure, so shapes can be manufactured Complex parts with large curvature changes.
(1) Free blow molding method
This is a simple blow molding. Its characteristic is that no mold is used, and the typical parts blown are spherical parts.
(2) Punch forming method
This method is to form a closed pressure space on the outside of the titanium plate cotton. After the titanium plate is heated to a superplastic temperature, under the pressure of compressed gas, the wool undergoes superplastic deformation and gradually approaches the surface of the mold until it is the same as the mold. Perfect fit to produce parts identical to the mold surface. The inner surface of the molded parts has high dimensional accuracy, accurate shape, and large aspect ratio. Mold processing is easier, but demoulding is difficult and the raw materials are expensive. The bottom of the part formed this way is thicker than the surrounding part.
(3) die forming method
Different from the punch forming method, a closed pressure space is formed inside the titanium sheet wool during the forming process. The outer surface of the formed parts has high dimensional accuracy and accurate shape. Parts can be demoulded more easily, saving raw materials. However, the depth and width are relatively small, and mold processing is also difficult. Parts formed this way are thinner at the bottom than around them.
3. Molding method
Use a coupling mold. The difference from ordinary pressing is that the temperature is high and the molding speed is much slower.
Since it is difficult to manufacture metal coupling molds at the superplastic temperature of titanium plates, and the matching accuracy is also difficult (especially for molds with complex shapes), superplastic forming of titanium plates is rarely used.

You Might Also Like

Send Inquiry